Cyberdyne Digital Gauge Installation

2 1/16” Ultragage with Memory Instructions

2 1/6” Ultragage instructions

Warning: Before doing any work on any kind of vehicle, disconnect the negative (-) battery cable. Failure to do so may result in burns, electrical shock, or other personal injuries and damage to vehicle.

Recommended installation technique:

Decide on a location to mount the gauge(s).
Drill, cut and do whatever it takes to get the location ready to install the gauge(s).
Install the sender(s) and switch(s) , if applicable. Refer to section 'sender installation'.
Install the gauge, but do not secure into place.
Make all wire connections. Refer to section 'Gauge, sender, and switch wire connections'
Make sure all gauges are functioning. If any problem refer to the section 'trouble shooting'.
Adjust warning indicators or fuel tank capacity. Refer to section 'understanding and setting warning indicators' or ' setting fuel tank capacity'.
Secure the gauge in place.
Read over sections 'memory recall and 'special functions'.

Gauge, sender and switch wire connections:

Note: For Vacuum, Boost, Vacuum-Boost gauges skip this section and go to 'Gauge, sender and switch connection using Cyberdyne MAP sender'. All other gauges should follow the instructions below.

Red wire: Ignition wire, hookup to a switched +12 volt ignition source. Example: Accessory fuse in fuse box.

Black wire: Ground wire, mate all black wires from the gauge, sender, switch, and hookup to a good ground. Example: Battery (-) terminal.

Purple wire: Dimmer wire, hookup to a switched light source. Example: Any switched light bulb>

White wire: Signal wire, mate the white wire from the gauge to the white wire from the sender.

Yellow wire: +5 volt accessory wire, if sender has a yellow wire mate the yellow wire from the gauge to the senders yellow wire. If sender does not have a yellow wire the cut off any bare wire and tie to a safe place.

Blue wire (if applicable): Memory recall wire, mate blue wire from the gauge to the blue wire on the switch.

Note: All wire should be routed away from the ignition system, spark plug wires or any type of electrical noise imposing wires. Any wire brought through the firewall should be secured through a rubber grommet.

Vacuum, Boost, Vacuum/boost Gauges only

Gauge, sender and switch wire connections using Cyberdyne MAP sender.

Red Wire: Ignition Wire, hookup to a switched +12 volt source. Example: Accessory fuse in fuse box.

Black Wire: Ground wire, mate the black wire from the gauge, switch and the uncoated wire from the MAP sender together and hookup to a good ground. Example: Battery (-) terminal.

Purple Wire: Dimmer wire, hookup to a switched light sourec. Example: Any switched light bulb.

White wire: Signal wire, mate the white wire from the gauge with the clear wire from the sender.

Yellow Wire: +5v accessory wire, mate the yellow wire from the gauge to the black wire from the sender.

Blue Wire (If applicable): Memory recall wire, mate the blue wire from the gauge to the blue blue wire on the switch.

Note: All wires should be routed away from the ignition system, spark plug wires or any type of electrical noise imposing wire. Any wire brought through the firewall should be secured through a rubber grommet.

Flitz